Rear Panel Description - D-Link xStack DGS-3120-48PC Hardware Installation Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch Hardware Installation Guide

Rear Panel Description

The rear panel contains an AC power connector, an outlet for an external redundant power supply, and two stacking
ports.
The AC power connector is a standard three-pronged connector that supports the power cord. Plug-in the female
connector of the provided power cord into this socket, and the male side of the cord into a power outlet. The Switch
automatically adjusts the power setting to any supply voltage in the range from 100 ~ 240 VAC at 50 ~ 60 Hz. An
optional external Redundant Power Supply (DPS-200 for DGS-3120-24TC/SC, DPS-500/DPS-500DC for DGS-3120-
48TC, and DPS-700 for DGS-3120-24PC/48PC) can be plugged into the RPS outlet displayed above. When the
internal power fails, this optional external RPS will take over all the power immediately and automatically. There are
also two stacking ports on the rear panel. These dedicated stacking ports are specially designed for high speed switch
stacking. The Switch supports a stacking cable length of up to 3 meters.
Figure 1- 13. Rear panel view of the DGS-3120-24TC
Figure 1- 14. Rear panel view of the DGS-3120-24SC
Figure 1- 15. Rear panel view of the DGS-3120-24SC-DC
Figure 1- 16. Rear panel view of the DGS-3120-24PC
Figure 1- 17. Rear panel view of the DGS-3120-48TC
Figure 1- 18. Rear panel view of the DGS-3120-48PC
8