Displaying Source Information; Using The Sleep Timer; Setting The Display Brightness - Onkyo TX-NR828 Owner's Manual

Displaying Source Information

You can display various information about the current
input source as follows.
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use DISPLAY on the AV
receiver.
The following information can be typically displayed.
Input source
Listening mode
Signal format *1
Sampling
frequency
Input signal
resolution
Output resolution
*1 If the input signal is digital, the signal format is displayed.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to
turn off automatically after a specified period.
1
Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The SLEEP indicator lights on the AV receiver's
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver
sleeps, press SLEEP. Note that if you press again on
SLEEP as the time being displayed is 10 minutes or
less, the sleep timer will go off.
En-52

Setting the Display Brightness

You can adjust the brightness of the AV receiver's
display, and switch the MASTER VOLUME indicator
off and on in conjunction.
1 Press RECEIVER once followed by DIMMER
repeatedly to cycle through the following
patterns:
• Normal brightness + indicator off.
• Dim brightness + indicator off.
• Dimmer brightness + indicator off.
• Normal brightness + indicator on (default).
Tip
• (North American models) Alternatively, you can use
DIMMER on the AV receiver.
Playback