Warning Displays - FujiFilm FinePix4900 ZOOM Owner's Manual

Warning Displays

e The table below lists the warnings that are displayed on the LCD monitor
Explanation Warning Displayed
The camera battery is low on
(Lit red)
charge.
No SmartMedia is loaded, or it is
loaded incorrectly.
The SmartMedia is not formatted.
• The SmartMedia terminals are
soild.
• The SmartMedia is damaged.
• The SmartMedia format is
incorrect.
The SmartMedia is fully recorded. Erase some images or use a SmartMedia
The SmartMedia is write-protected. Use a SmartMedia that is not write-
An attempt was made to playback
a frame not recorded on this
camera.
The frame number has reached
999-9999.
120
Remedy
Replace or recharge the battery.
Load the SmartMedia (3.3V) in the correct
direction.
Format the SmartMedia.
Wipe the contact area on the SmartMedia
with a soft dry cloth. It may be necessary to
format the SmartMedia. If the error message
is still displayed, replace the SmartMedia.
that has ample free space.
protected.
Images cannot be played back.
Switch the Frame NO. Memory function off
and use a formatted SmartMedia to take the
picture.
Explanation Warning Displayed
There is a strong likelihood of
camera shake because the
shutter speed is slow.
A protected frame was erased.
The AF (auto focus) cannot work
AF effectively.
Aperture/Shutter speed display
Outside the AE continuous
range.
(Lit red)
The image you tried to erase
has a DPOF print setting.
The DPOF file contains an error.
Alternatively, the DPOF file was
set up on a different device.
Prints were specified for more
than 1000 frames in the DPOF
frame settings.
• Camera malfunction or fault.
Remedy
Use flash photography. However, a tripod
should be used for some scenes and modes.
Remove the protection.
• If the shot is too dark, move at least 2 m
away from the subject and try again.
• Use AF lock to take the picture.
The shot can be taken, but the exposure will
not be correct.
When you erase the image, the DPOF
settings for that image are deleted at the
same time.
Press the MENU/OK button to create a new
DPOF file and specify all the DPOF settings
again.
The maximum number of frames for which
prints can be specified on the same
SmartMedia is 999.
• Switch the camera on again, taking care not
to touch the lens.
• Turn the camera off and on again a few times.
If this does not resolve the problem, contact
an authorized FUJIFILM service center.
121