Switching On And Off; Setting The Date And Time - FujiFilm FinePix1300 Owner's Manual

SWITCHING ON AND OFF

1
Slide the POWER switch in the direction of the arrow to
switch the camera on or off. The viewfinder lamp lights
[green] when you switch the camera on.
If you have not set the date, a confirmation screen
d c
appears. Press " " or " " to select the desired option
and then press the "MENU/OK" button.
➡
"SET": The date setting screen appears. ( P.18)
"NO" : The camera switches to Photography, Playback
or Setup mode.
G
!
If you have not set the date, the confirmation screen appears
every time you switch the camera on. You should set the date
16
immediately.
2
Blank
On On
With the LCD monitor on, you can check the
remaining charge in the battery.
➀
Battery has ample charge.(No indicator
displayed.)
➁
Battery charge low. Replace or recharge the
battery as it will run out shortly.
➂
The battery is exhausted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the battery.
G
!
If the battery charge is depleted, you may not be
able to switch the LCD monitor on.
N N
Auto Power Off Function
If the camera is left on for two minutes or
more, the Auto Power Off function
automatically switches the camera off.
Holding down the "MENU/OK" button as
you switch the camera on disables the
Auto Power Off function.

SETTING THE DATE AND TIME

➀
1
➁
➀
F
Set the Mode dial to " ".
➁
Switch to the SET-UP screen.
If the date is cleared when you switch the
camera on, a confirmation screen appears. If
you selected " ", proceed from step
SET
(➡P.18) .
➀
2
➀
Use the " " button to select "DATE/ TIME".
ab
➁
Press the "MENU/OK" button.
G
!
Once the AC power adapter has been connected or
the batteries have been loaded for 10 minutes or
more, the settings will be retained for roughly 20
minutes even if you remove the batteries and
disconnect the AC power adapter. Check settings such
3
as the date and time after you replace the batteries.
G
!
See P.56 for more information on the "
➁
1
17
F
" menu.