Installing A Pci Card - Dell XPS /Dimension Gen 2 Service Manual

8. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
9. Connect your computer and devices to electrical outlets, and then turn them on.
10. Click the Start button, right-click My Computer, and then click Properties.
11. Click the General tab.
12. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
PCI Cards
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.
Your Dell™ computer provides slots for up to four 32-bit, 33-MHz cards. For more information, see "Specifications."
NOTE: For optimum performance, install a PCI sound card only in PCI slot 3 or 4 and a modem card only in PCI slot 2, 3, or 4.

Installing a PCI Card

1. If you are replacing a card, remove the current driver for the card from the operating system.
2. Follow the instructions in "Before You
3. Open the computer cover.
4. Press the lever on the card retention arm and raise the retention arm.
5. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with
6. If you are replacing a card that is already installed in the computer,
If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.
7. Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
Begin."
remove the card.
step 7.