Installing The Wlan Card; Removing The Memory - Dell OptiPlex 3011 AIO Owner's Manual

Installing the WLAN Card

1. Slide the WLAN card into its slot and tighten the screw to secure it to the system board.
2. Connect the antenna cables to the WLAN card.
3. Install:
a) system board cover
b) back cover
c) VESA stand
d) stand cover
4. Follow the procedures in

Removing the Memory

1. Follow the procedures in
2. Remove:
a) stand cover
b) VESA stand
c) back cover
3. Remove the screw that secures the memory stand to the computer and slide to release the memory cover from the
computer. Remove the memory cover from the computer.
4. Pry the retention clips away from the memory module until it pops up. Lift and remove the memory module from its
connector.
16
After Working Inside Your Computer .
Before Working Inside Your Computer .