Adjusting Loudness; Using Subwoofer Output; Using The High Pass Filter - Pioneer AVIC-F30BT Operation Manual

Customising preferences
1 Display the "AV Sound Settings"
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 151.
2 Touch [Sonic Center Control].
3 Touch [c] or [d] to select a listening po-
sition.
p The larger the value of the range: "Left7" to
"Right7" setting, the greater the delay of
the speaker output.
p When "Left" is set, the left speaker output
is delayed. When "Right" is set, the right
speaker output is delayed.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Display the "AV Sound Settings"
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 151.
2 Touch [Loudness].
Each time you touch [Loudness], the level is
selected in the following order:
Off — Low — Mid — High

Using subwoofer output

The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
p This function is not available when "Sub
Woofer" is "Off".
1 Display the "AV Sound Settings"
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 151.
2 Touch [Sub Woofer].
3 Touch [On].
The subwoofer output is turned on.
# If you touch [Off], the subwoofer output is
turned off.
4 Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
5 Touch [+] or [–] next to "Level" to adjust
the output level.
"+6" to "–24" is displayed as the level is in-
creased or decreased.
6 Touch [c] or [d] next to
"Frequency(Hz)" to select cut-off fre-
quency.
Each time you touch [c] or [d], cut-off fre-
quencies are selected in the following order:
50Hz — 63Hz — 80Hz — 100Hz — 125Hz
Only frequencies lower than those in the se-
lected range are output from the subwoofer.

Using the high pass filter

When you cut lower sounds from the subwoo-
fer output frequency, activate HPF (high pass
filter). Only frequencies higher than those in
the selected range are output from the front or
rear speakers.
1 Display the "AV Sound Settings"
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 151.
2 Touch [HPF].
Each time you touch [HPF] selects cut-off fre-
quencies in the following order:
Off — 50Hz — 63Hz — 80Hz — 100Hz —
125Hz
Chapter
26
157
Engb