Exiting The Viewer - NEC NP-PH1400U User Manual

• Index file (extension:.idx)
• Index files, which is converted by using Viewer PPT
Converter 3.0, will appear in the Thumbnail screen.
Only folders and JPEG files converted by using
Viewer PPT Converter 3.0 will appear in the Thumbnail
screen.
• To select slideshow of index files, open the [PRESENTA-
TION] folder in the DRIVE LIST screen.
However, index files will not appear. Only folders and
JPEG files will appear.
• Up to four index folders in your USB and shared folder
are displayed.The four folders will be displayed in reverse
chronological order
• When you insert the USB memory device storing index
with the Viewer in operation, the content of the index files
will be displayed.
NOTE:
• The play mode (MANUAL/AUTO) for slides of index file works in
the following way:
In case of [MANUAL] for [PLAY MODE]
When you select [OPTIONS] → [SLIDE SETTING] → [PLAY MODE]
→ [MANUAL], index files will be set for manual playback in regard-
less of whether [INTERVAL] is set.
In case of [AUTO] selected for [PLAY MODE]
When you select [OPTIONS] → [SLIDE SETTING] → [PLAY MODE]
→ [AUTO], index files will be set for auto playback at intervals
specified by using [INTERVAL].
When, however, [-1] is selected for [INTERVAL], the play mode will
be set for auto playback according to the setting for [OPTIONS] →
[SLIDE SETTING] → [INTERVAL].
7. Remove the USB memory from the projector.
Return to the drive list screen. Make sure that the LED on
the USB memory is not flashing before removing the USB
memory.
NOTE: If you remove the USB memory from the projector with a slide
displayed, the projector may not operate correctly. If this happens,
turn off the projector, turn off the main power switch, and unplug the
power cord. Wait 3 minutes, then connect the power cord, turn on
the main power switch, and turn on the projector.

Exiting the Viewer

1. Press the SOURCE button to select a source other than
[VIEWER].
A press of the SOURCE button will display the source select
screen.
A few more presses of the SOURCE button will display
another source.
• To exit the Viewer using the remote control, select a
source other than [VIEWER].
85
4. Using the Viewer
XXXX Motors