❹ Selecting A Source; Selecting The Computer Or Video Source - NEC NP-PH1400U User Manual

❹ Selecting a Source

Selecting the computer or video source

NOTE: Turn on the computer or video source equipment connected to the projector.
Detecting the Signal Automatically
Press the SOURCE button once.The projector will search for the available
input source and display it. The input source will change as follows:
COMPUTER1 → COMPUTER2 → COMPUTER3 → HDMI → DisplayPort
→ VIDEO → S-VIDEO → VIEWER → SLOT → COMPUTER1 → ...
• With the SOURCE screen displayed, you can press the SOURCE
button a few times to select the input source.
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
Press any one of the COMPUTER1, COMPUTER2, COMPUTER3, HDMI,
DisplayPort, VIDEO, S-VIDEO, VIEWER, NETWORK, or SLOT buttons.
Selecting Default Source
You can set a source as the default source so that it will be displayed
each time the projector is turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the ▶ button twice to select [SETUP] and press the ▼ but-
ton or the ENTER button to select [BASIC].
3. Press the ▶ button five times to select [OPTIONS(2)].
4. Press the ▼ button five times to select [DEFAULT SOURCE
SELECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be displayed.
(→ page 136)
5. Select a source as the default source, and press the ENTER but-
ton.
6. Press the EXIT button a few times to close the menu.
2. Projecting an Image (Basic Operation)
22