Performance Edit - Yamaha MOX8 Reference Manual

VOICE PERF

Performance Edit

Each performance can contain a maximum of four Parts. There are two types of Performance Edit displays: those for
Common Edit to edit the settings common to all four Parts, and those for Part Edit to edit the individual Parts. This
section explains the parameters for Common Edit and Part Edit.
Common Edit
[PERFORM]  Performance selection  [EDIT]  [COMMON]
Operation
[F1] GENERAL
[SF1] NAME
From this display you can assign the category (sub and main) of the selected Performance, and create a name for the
Performance. The Performance name can contain up to 20 characters. For detailed instructions on naming, see the
"Basic Operation" of the Owner's Manual.
[SF2] PLY MODE (Play Mode)
SplitPoint
Determines the note number of the Split point, which divides the keyboard into two different sections.
Settings:
C#-2 – G8
NOTE
When the "SplitLo/Up" parameter of each Part is set to "both," this parameter will have no effect.
NOTE
Sound is produced only when you play notes within the area that matches both the Split setting and Note Limit setting.
NOTE
You can also set the note directly from the keyboard, by holding down the [SF6] KBD button and pressing the desired key.
SplitSwitch
Determines whether the settings of the Split Point and the Split Lower/Upper position in the Part parameter are enabled
(on) or disabled (off).
Settings:
off, on
[SF3] EQ OFS (EQ Offset)
This is a parametric EQ featuring three bands (High, Mid and Low). You can attenuate or boost the level of each
frequency band (High, Mid, Low) to change the Voice sound. Determines the offset value for the same parameters in the
[F3] EQ display (page 67).
FREQ (Frequency)
Determines the frequency for each frequency band.
GAIN
Determines the level gain for the Frequency (above), or the amount the selected frequency band is attenuated or
boosted. The higher the value, the greater the Gain. The lower the value, the lesser the Gain.
Q
Determines the Q (bandwidth) for the Mid band. The higher the value, the smaller the bandwidth. The lower the value,
the wider the bandwidth.
Settings:
-64 – +0 – +63
[SF4] PORTA (Portamento)
This display allows you to set the Portamento-related parameters. The parameters are the same as in Performance Play.
See page 56.
MOX6/MOX8 Reference Manual
SONG PATTERN MIX MASTER REMOTE UTILITY QUICK SET FILE
Performance Mode
Performance Play
[F1] PLAY
[F2] VOICE
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F1] COMMON
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
[F6] OUT CH
Performance Edit
Common Edit
[F1] GENERAL
[F2] OUT/MFX
[F3] MEQ
[F4] USB I/O
[F5] A/D IN
[F6] EFFECT
Part Edit
[F1] VOICE
[F2] OUTPUT
[F3] EQ
[F4] TONE
[F5] RCV SW
Performance Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Performance Record
[F1] SETUP
[F2] REC TR
[F3] OTHER
[F5] CLICK
[F6] INFO
Supplementary Information
59