Reinstalling And Updating Software; To Recover The Factory Installation Of Your Hard Disk - HP OmniBook 510 - Notebook PC Reference Manual

Reinstalling and Updating Software

CAUTION
Troubleshooting and Maintenance
Reinstalling and Updating Software
You can use the Recovery CD to recover the original factory software for your computer.
The Recovery CD also provides Windows drivers specific to your computer to configure
a custom system. You can find drivers in these locations:
• On your computer's hard drive under C:\hp\Drivers.
• On the Recovery CD under \hp\Drivers.
• On the HP Business Support web site (www.hp.com/go/bizsupport). This web site
contains the latest updates of software drivers for different operating systems.

To recover the factory installation of your hard disk

You can use the Recovery CD to reinstall the original factory software on your
computer's hard disk. You can also use the same process to create a larger Utility
partition on your hard disk, or to create a Utility partition on a new hard disk. The hidden
Utility partition contains the e-Diagtools diagnostic tests and stores hibernation data for
Windows 98 and other operating systems that don't provide hibernation.
This procedure formats the computer's hard disk drive and erases all data on the
disk. After the hard disk is formatted, you'll need to reinstall your applications.
Do not interrupt the following process or unplug the AC adapter until the process
is complete.
1. Important: back up all data from your hard disk. The following steps delete all data
from the disk.
2. Plug in the AC adapter.
3. Insert the Recovery CD in the CD-ROM/DVD drive in the expansion base. If the
computer is turned off, insert a straightened paper clip into the hole on the front of the
drive to open the drive.
–or–
If you have a PC Card or parallel port CD-ROM drive, connect it and insert the
Recovery CD. Also connect the floppy drive and insert the Support Utility disk—see
"To create a Support Utility disk" on page 139.
138 Reference Guide