Installing The Shared Perc 8 Controller - Dell PowerEdge VRTX User Manual

Figure 1. Removing and Installing the Shared PERC 8 Controller
1. release lever (2)
2. storage-controller card holder
3. storage controller card
4. battery
5. heatsink

Installing The Shared PERC 8 Controller

To install the Shared PERC 8 controller:
1. Perform a controlled shutdown of the system and attached peripherals.
2. Disconnect the system from the electrical outlet and remove the system cover.
3. Install the storage controller in the appropriate controller slot.
CAUTION: When removing or replacing the Shared PERC 8 controller, hold the card by its edges marked by
the blue touch points. Do not handle the card while holding the battery or the heatsink.
For more information, see the relevant figures in
4. Replace the system cover.
18
6. touch points (2)
7. storage-controller card connector on the
system board
8. guide pins (2)
Removing The Shared PERC 8 Controller.