Nic Indicator Codes - Dell PowerEdge R820 Owner's Manual

Item Indicator, Button, or
Connector
6 PCIe expansion card slots
(3)
7 iDRAC7 Enterprise port
8 System identification
connector
9 System identification button
10 Power supply (PSU1)
11 PCIe expansion card slots
(2)
12 Power supply (PSU2)

NIC Indicator Codes

Figure 5. NIC Indicator
1. link indicator
2. activity indicator
14
Icon Description
Allows you to connect a PCI Express expansion card.
Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
Allows you to connect the optional system status indicator
assembly through the optional cable management arm.
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the LCD panel on
the front and the system status indicator on the back
flashes until one of the buttons is pressed again.
Press to toggle the system ID on and off. If the system
stops responding during POST, press and hold the system
ID button for more than five seconds to enter BIOS
progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC setup)
press and hold the button for more than 15 seconds.
AC 750 W or 1100 W
Or
DC 1100 W (when available)
Allows you to connect a PCI Express expansion card.
AC 750 W or 1100 W
Or
DC 1100 W (when available)