Four-post Threaded Configuration
For this configuration, you must remove the flange ear castings from each end of the ReadyRails
1
assemblies. Use a Torx driver to remove the two screws from each flange ear and remove each
casting. Refer to
Figure
For each rail, attach the front and rear flanges to the post flanges with two user-supplied screws at
2
each end. Refer to
Figure 4-4. Four-post Threaded Configuration
4-4, step 1. Retain the castings for future rack requirements.
Figure
4-4, step 2.
Installing the S4820T
|
27