Cautions - Sharp AR-121E Operation Manual

CAUTIONS

Follow the cautions below when using this copier.
G The fusing area is hot. Exercise care in this area when removing misfed
paper.
1
G
Do not look directly at the light source. Doing so may damage your eyes.
G
Do not switch the copier rapidly on and off. After turning the copier off, wait 10
to 15 seconds before turning it back on.
G
Copier power must be turned off before installing any supplies.
G
Place the copier on a firm, level surface.
G
Do not install the copier in a humid or dusty location.
G
When the copier is not used for a long time, for example, for consecutive
holidays, turn the power switch off and remove the power cord from the outlet.
G
When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
G
Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
G
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Cautions on laser
Wave length
Pulse times
Output power
4
chap-1_AR121151EX.p65
770 nm - 795 nm
11.82 µs / 7 mm
0.17 mW ± 0.01 mW
4 30/11/00, 19:07