Copier Trouble; Misfeed Removal; A Misfeed In The Paper Feed Area - Sharp AR-121E Operation Manual

6

COPIER TROUBLE?

This chapter describes misfeed removal and troubleshooting.

MISFEED REMOVAL

When the misfeed (
of a misfeed.
Open the side cover while pressing the side cover open button.
1
Check the misfeed location. Remove the misfed paper following the instructions for
2
each location in the illustration below.
If
If the misfed paper is seen from
this side, proceed to C Misfeed in
the transport area . (p. 27)

A Misfeed in the paper feed area

Gently remove the misfed paper from the paper feed area as shown in the illustration.
1
When
area, pull out the paper tray and remove the misfed paper. If the paper cannot be
removed, proceed to "B Misfeed in the fusing area".
The fusing unit is hot. Do not touch the fusing unit when removing misfed paper.
Doing so may cause a burn or other injury.
G
Do not touch the photoconductive drum (green portion) when removing the
misfed paper. Doing so may damage the drum and cause smudges on copies.
G
If the paper has been fed through the manual bypass, do not remove the
misfed paper through the manual bypass. Toner on the paper may stain the
paper transport area, resulting in smudges on copies.
chap-6_AR121151EX.p65
) indicator blinks or
blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 25)
blinks in the display and the misfed paper is not seen from the paper feed
25
blinks in the display, the copier will stop because
If paper is misfed here, proceed to B
Misfeed in the fusing area . (p. 26)
If paper is misfed here, proceed to A
Misfeed in the paper feed area . (p. 25)
30/11/00, 19:08
6
25