Table of Contents
Advertisement
SPECIAL FEATURES ON YOUR VCR
POWERSAVE FEATURE
To meet new power regulations your VCR can be placed in POWERSAVE mode. In
POWERSAVE mode the VCR power consumption is reduced to below 1 Watt.
POWERSAVE MODE
1.
Press
STAND BY
2.
Press
STAND BY
display will appear blank.
The VCR power consumption will now be below 1 Watt.
DISENGAGING POWERSAVE MODE
Either
Press
STAND BY
Or
Press
STOP
NOTES:
•
With poor signal conditions an increase in noise may be observed on the screen in
POWERSAVE mode.
•
When entering STANDBY, noise may be observed.
•
If a signal is input from an AV source, the VCR may not go into true POWERSAVE mode.
•
When disengaging POWERSAVE mode from the VCR press the STANDBY/POWERSAVE
button.
CHILD LOCK
You can lock your VCR with this feature. It will work even when the VCR is in standby/
powersave, preventing children from operating the VCR.
TO ENGAGE CHILD LOCK
Press and hold
flashes and then
has been activated.
Regardless of what other operating buttons are touched, the VCR will continue to operate in
its present mode. If CHILD LOCK is activated during playback, once the tape reaches its end,
the VCR will automatically rewind the tape, eject it, and turn the power off.
TO DISENGAGE CHILD LOCK
Press and hold
starts flashing and then disappears. CHILD LOCK is disengaged.
NOTES:
•
If you attempt to change modes by pressing another button while CHILD LOCK is on,
the
indicator will flash on the VCR display.
•
If power is interrupted for more than 60 seconds (due to power failure etc), CHILD LOCK
may disengage.
(
) to place the VCR in STANDBY mode.
(
) again to place the VCR in POWERSAVE mode. The VCR digital
(
) to return the VCR to STANDBY mode.
(
) to use the VCR.
on the remote control for about 2 seconds.
remains lit on the VCR display confirming that CHILD LOCK
for about 2 seconds.
GB-32
Advertisement
Table of Contents
