Immediate Recording - Sharp VC-MH703HM Operation Manual

BASIC OPERATION

IMMEDIATE RECORDING

SELECTION OF A CHANNEL
Select the channel by using the number buttons on the remote control, or select the
next/previous channel by pressing
To change between single digit and 2-digit channel numbers, press
For example, for channel 24, press
You can record the channel you are watching or a different channel.
1.
Insert a video tape into your VCR.
2.
Select the channel you wish to record on the VCR.
3.
To start recording, press
4.
To pause during recording, press
5.
To continue recording, press
6.
To stop recording, press
SIMPLE TIMED RECORDING:
1.
To specify a stop time, press
2.
Each additional press of
the stop time by 10 minutes.
3.
To stop recording at any time, press
STOP ( ) once.
NOTES:
• If the tape ends before the recording is complete the VCR will stop recording, rewind,
eject the tape and place the VCR into STANDBY mode, or just eject the tape and place
the VCR in STANDBY timer mode if the VCR is in timer record mode.
• If the VCR ejects the video tape when you press
protected. i.e. record protection tab has been removed.
If problems persist contact the SHARP Helpline on tel: 0990-274277
CHANNEL [
AM/PM
AM/PM
REC
( ).
PAUSE/STILL
REC
( ).
STOP ( ) once.
REC ( ).
REC ( ) will delay
13
or ].
AM/PM
then press 2 4 .
( ).
STOP 15:30
7 8
AM/PM
0
REW
REC
TAPE
SPEED SLOW
Remote Control
REC ( ) the tape is record
AM/PM
.
9
CHANNEL
INPUT SELECT
FF
PLAY / X2
PAUSE/STILL
STOP
DPSS
TV/VCR