Immediate Recording - Sharp VC-MH71SM Manual

VC-MH71SM ENGLISH.book Page 10 Tuesday, April 20, 1999 10:52 AM
BA SI C OPERA T I ON
I M M ED I A T E RECORD I N G
SELECT I ON OF A CH A N N EL
Select the channel by using the number buttons on the remote control, or select the
next/previous channel by pressing
To change between single digit and 2-digit channel numbers, press
For example, for channel 24, press
You can record the channel you are watching or a different channel.
1.
Insert a video tape into your VCR.
2.
Select the channel you wish to record on the VCR.
3.
To start recording, press
4.
To pause during recording, press
5.
To continue recording, press
6.
To stop recording, press
SI M PLE T I M ED RECORD I N G:
1.
To specify a stop time, press
2.
Each additional press of
the stop time by 10 minutes.
3.
To stop recording at any time, press
ST OP
NOTES:
• If the tape ends before the recording is complete the VCR will stop recording and
rewind, or eject if the VCR is in timer record mode.
• If the VCR ejects the video tape when you press
protected. i.e. record protection tab has been removed.
Downloaded from: http://www.usersmanualguide.com/
CH A N N EL
A M /PM
REC (
REC
ST OP (
REC
REC (
( ) once.
[ or ].
then press 2 4
).
PA U SE/ST I LL ( ).
( ).
) once.
( ).
) will delay
REC (
GB-10
A M /PM .
.
STOP 15:30
) the tape is record