Peripheral Configuration - NEC Express5800/120Rh-1 User Manual

Peripheral Configuration

IMPORTANT:
overlapped with others. If the value set for the interrupt or base I/O
address is used in another resource, the yellow asterisk (*) appears.
Reset any item with the yellow asterisk properly.
Option
Serial Port A
Base I/O
address
Interrupt
Serial Port B
Base I/O
address
Interrupt
USB Controller
USB 2.0 Controller
Parallel ATA
Serial ATA
SATA Controller
Mode Option
SATA AHCI
SATA RAID
Note that the interrupt and/or base I/O address are not
Parameter Description
Disabled Selects whether serial port A is enabled or
[Enabled] disabled.
[3F8] Selects the base I/O address for serial port
2F8 A.
3E8
2E8
IRQ 3 Selects the interrupt for a serial port A.
[IRQ 4]
Disabled Selects whether serial port B is enabled or
[Enabled] disabled.
3F8 Selects the base I/O address for serial port
[2F8] A.
3E8
2E8
[IRQ 3] Selects the interrupt for a serial port A.
IRQ 4
[Enabled] Selects the USB controller is enabled or
Disabled disabled.
Disabled Selects the USB 2.0 controller is enabled or
[Enabled] disabled.
Disabled Selects parallel ATA is enabled or disabled.
[Enabled]
Disabled Selects whether the serial ATA is enabled or
[Enabled] disabled.
Compatible Selects an operation mode of onboard
[Enhanced] SATA controller. Displayed only when Serial
ATA is enabled.
Compatible mode:
SATA drives are automatically detected
and recognized as legacy mode.
Enhanced mode:
SATA drives are automatically detected
and recognized as native mode.
Disabled Selects whether AHCI (Advanced Host
[Enabled] Controller Interface) is enabled or disabled.
Displayed only when [Enhanced] is selected
for [SATA Controller Mode Option].
Disabled When set to [Enabled], this menu appears if
[Enabled] RAID configuration jumper switch is set to
[RAID enable] position. See Chapter 4 for
details.
Configuring Your Server 4-11
Your Setting
[ ]: Factory-set