Python 700 Owner's Manual page 15

p p r r o o g g r r a a m m m m i i n n g g 2 2 - - w w a a y y r r e e m m o o t t e e
To enter programming mode
Press and hold all four remote control buttons simultaneously
until one long beep is heard. Programming mode is now entered.
Beeps On/Off
Press to select beeps On/Off. One beep is notification beeps
On, Two beeps is notification beeps Off. The notification beeps
are programmed On from the factory and can be programmed
Off if they are not desired. When programmed Off the remote
will only flash the LEDs as notification of a command page or
an alarm page.
2-Way LED Remote battery low notification
Press to select low battery notification On/Off. One beep is
low battery notification On. Two beeps is low battery notifica-
tion Off. The Low battery Beeps are programmed On from the
factory and can be programmed Off if they are not desired.
When programmed Off the remote will not give any notification
that the battery charge level in the remote is low.
Page notification
The remote control can be programmed to notify the user of a
page (audibly beeping if the vehicle's status changes, e.g. door
unlocked, engine started, vehicle violation, etc.). On the 2-way
LED remote press to select page On/Off. One beep is page
On, Two beeps is page Off. When programmed off the remote will
not give any notification that a page was received from the vehicle.
16
© 2005 directed electronics, inc.