New Construction; Troubleshooting - JBL SOUNDPOINT SP5II Owner's Manual

NEW CONSTRUCTION

You will need to purchase the correct rough-in frame kit for your model:
SPEAKER MODEL
SP5II
SP6II
SP6CII
SP6CSII
SP8II
SP8CII
Detailed installation instructions are supplied with the rough-in kit.
PAINTING THE SPEAKER
FRAME AND GRILLE
SoundPoint Series loud-
speakers can be painted to
match any décor. If you wish
to change their color, the satin
finish on the grille and frame
will function as a primer coat.
Before painting, install the
paint shield (inner section of
template in the assembly kit)
securely into the recess in the

TROUBLESHOOTING

IF THERE IS NO
SOUND FROM ANY
OF THE SPEAKERS:
• Check that receiver/amplifier
is on and a source is playing.
• Check all wires and connec-
tions between receiver/ampli-
fier and speakers. Make sure
all wires are connected. Make
sure none of the speaker wires
are frayed, cut, punctured or
touching each other.
• Review proper operation of
your receiver/amplifier.
IF THERE IS NO
SOUND COMING
FROM ONE SPEAKER:
• Check the "Balance" control
on your receiver/amplifier.
• Check all wires and connec-
tions between receiver/ampli-
fier and speakers. Make sure
all wires are connected. Make
ROUGH-IN FRAME KIT
RIF5
RIF6
RIF6C
RIF6CS
RIF8
RIF8C
baffle. This will protect the
speaker components and baf-
fle from paint residue. Use a
high-quality spray paint, and
apply a thin coat of color.
Be certain the grille perfora-
tions remain free of paint.
Filling them with paint will
diminish the sound quality.
sure none of the speaker wires
are frayed, cut, punctured or
touching each other.
IF THERE IS LOW (OR
NO) BASS OUTPUT:
• Make sure the connections
to the left and right "Speaker
Inputs" have the correct polar-
ity (+ and –).
• Consider adding a powered
subwoofer to your system.
• In Dolby Digital or DTS modes,
make sure your receiver/
processor is correctly config-
ured. When using a subwoofer,
make sure the subwoofer
output of the receiver/ proces-
sor has been enabled. If no
subwoofer is being used,
make sure the left and right
front and rear speakers have
been configured as "LARGE."
See your receiver/processor's
Note: Gently remove the
acoustical foam blanket from
the grille before painting.
Reattach the blanket after
the paint has dried.
owner's manual for futher
information on correct speaker
configuration in Dolby Digital,
DTS and other surround sound
modes.
IF THE SYSTEM PLAYS
AT LOW VOLUMES
BUT SHUTS OFF
AS VOLUME IS
INCREASED:
• Check all wires and connec-
tions between receiver/ampli-
fier and speakers. Make sure
all wires are connected. Make
sure none of the speaker wires
are frayed, cut , punctured or
touching each other.
• If more than one pair of main
speakers is being used, check
the minimum-impedance
requirements of your
receiver/amplifier.
7