Troubleshooting - Maytag Neptune MAH-3 Use & Care Manual

Hide thumbs Also See for Neptune MAH-3:
Table of Contents

Advertisement

Available languages

Available languages

DC68-02030B-01 MAH-3
12/15/05
S
TORING THE
Washers can be damaged if water is not removed from hoses
and internal components before storage. Prepare the washer
for storage as follows:
• Select the Quick Wash cycle and add bleach to the
automatic dispenser. Run the washer through the cycle
without a load.
• Turn the water faucets off and disconnect the inlet hoses.
T
ROUBLESHOOTING
C
HECK THESE POINTS IF YOUR
Freshening your
washer
The washer will not
start
No water or
insufficient water
supply
Detergent remains in
the automatic
dispenser after the
wash cycle is complete
Washer vibrates or
is too noisy
3:11 PM
Page 14
C
W
LOTHES
ASHER
M
N
AYTAG
• See Cleaning the Interior, page 11.
• Make sure door is firmly closed.
• Make sure the washer is plugged in.
• Make sure the water source faucets are turned on.
• Make sure to press the Cycle Selector dial to start the washer.
• Make sure the Control Lock is not activated, see page 6.
• Before the washer starts to fill, it will make a series of clicking noises to check the door lock
and do a quick drain.
• Turn both faucets on fully.
• Make sure the door is tightly closed.
• Make sure the washer is plugged in.
• Check fuse or reset circuit breaker.
• Press the Cycle Selector dial to start the washer.
• Straighten water inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Open and close the door, then press the Cycle Selector dial.
• Make sure the washer is running with sufficient water pressure.
See Installation Instructions.
• Make sure the Detergent Selector is in the upper position when using granular detergent.
• Make sure the washer is set on a level surface. If the surface is not level, adjust the washer
feet to level the appliance. See Installation Instructions.
• Make sure that the shipping bolts are removed. See Installation Instructions.
• Make sure the washer is not touching any other object.
• Make sure the laundry load is balanced.
• Disconnect the clothes washer from the electrical
supply and leave the washer door open to let air
circulate inside the tumbler.
• If the washer has been stored in below-freezing
temperatures, allow time for any water left over in the
washer to thaw out before use.
For information on long-term storage or storage of your
washer during extreme cold temperatures,
call Customer Service toll-free at
1-800-688-9900 USA or 1-800-688-2002 Canada.
U.S. customers using TTY for deaf, hearing impaired or
speech impaired, call 1-800-688-2080.
W
...
EPTUNE
ASHER
®
12
C
.
ONT

Advertisement

Chapters

Table of Contents
loading

Table of Contents