Cooling Your Room - Samsung AW Series Owner's Instructions Manual

Cooling Your Room

Remote Control
Control Panel
8
E-
You must select the Cool mode if you wish to lower the temperature in your
room. You can also set the fan speed. When you operate the air conditioner, air
flow blades are open and half closed automatically to give the proper air flow.
1
If necessary, press the
◆ The air conditioner starts up in the mode selected
Result:
when the unit was last used.
◆ The unit beeps twice.
☛
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
◆
Plugged in
◆
Stopped
It will start up automatically after about three minutes.
2
If the temperature is not displayed on the control panel:
◆
Press the
or
◆
Press the
temperature is displayed.
◆ The unit beeps each time you press the
Result:
◆ The air conditioner starts up in the Cool mode.
➢
You can change modes at any time.
3
To adjust the temperature, press the
control one or more times until the required temperature is displayed.
To adjust the temperature, press the
or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
◆ Each time you press the temperature buttons:
Result:
– The temperature is adjusted by 1°C and
displayed on the control panel
– The unit beeps
◆ The air conditioner starts cooling if the room temperature is
higher than the selected temperature.
4
To set the fan speed to...
High
Med
Low
Result: Each time you press a button, the unit beeps.
5
To control the direction of the air flow, refer to page 10~11.
(On/Off) button.
button on the remote control
button on the unit one or more times until the
or
or
Then...
◆ Press the
button on the remote control.
or
◆ Press the
button on the unit until F3
lights up
◆ Press the
button on the remote control.
or
◆ Press the
button on the unit until F2
lights up
◆ Press the
button on the remote control.
or
◆ Press the
button on the unit until F1
lights up
button.
button on the remote
button on the unit one