Hardware Installation; Hardware - Connectors External Connectors; Hardware – Connectors 6.1 External Connectors - RME Audio Hammerfall DSP System MADI User Manual

Pci busmaster digital i/o card 64 channels madi interface 24 bit / 96 khz digital audio stereo analog monitoring 128 x 64 matrix router 2 x midi i/o midi embedded in madi quick boot
Hide thumbs Also See for Hammerfall DSP System MADI:
Table of Contents

Advertisement

5. Hardware Installation

Before installing the PCI card, please make sure the computer is switched off and the
power cable is disconnected from the mains supply. Inserting or removing a PCI card while
the computer is in operation can cause irreparable damage to both motherboard and card!
1. Disconnect the power cord and all other cables from the computer.
2. Remove the computer's housing. Further information on how to do this can be obtained
from your computer's instruction manual.
3. Important: Before removing the HDSP MADI from its protective bag, discharge any static in
your body by touching the metal chassis of the PC.
4. Prior to installation: Connect the HDSP MADI card to the Expansion Board using the sup-
plied flat ribbon cable.
5. Insert the HDSP MADI firmly into a free PCI slot, press and fasten the screw.
6. Insert the Expansion Board and fasten the screw.
7. Replace the computer's housing.
8. Reconnect all cables including the power cord.
6. Hardware - Connectors
6.1 External Connectors
The bracket of the main-
board has two MADI inter-
faces, optical and coaxial
input and output each, a
MADI error LED and the
analog stereo output.
Identical signals are avail-
able at both the optical
and the coaxial output. An
obvious use for this would be to simply connect two devices, i.e. using the HDSP MADI as a
splitter (distribution 1 to 2).
The
Expansion
Board's
bracket
has
the
clock input and output.
Next to the input BNC
socket, a green LED dis-
plays the word clock in-
put's LOCK state. Be-
tween the BNC sockets,
75 Ohm word clock termi-
nation can be activated
and verified by a yellow LED.
The included breakout cable is connected to the 9-pin Mini-DIN connector and provides two
MIDI inputs and outputs via four 5-pin DIN connectors.
Note: If neither word clock I/O nor MIDI I/O is required, it's not necessary to install the Expan-
sion Board at all.
word
User's Guide HDSP MADI © RME
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hammerfall hdsp madi

Table of Contents