Samsung VP-DC161Wi Owner's Instruction Manual page 119

ENGLISH
Troubleshooting
 If these instructions do not solve your problem, contact your
nearest Samsung authorized service certre.
Symptom Explanation/Solution
You cannot switch the Check the Battery Pack or the AC Power

DVD Camcorder on. adapter.
You have left the DVD Camcorder set to

STBY for more than 5 minutes without
The DVD Camcorder using it. To turn on the DVD Camcorder,
shuts off automatically. press the [Start/Stop] button.
The Battery Pack is fully exhausted. Replace

it with a fully charged charged battery pack.
The atmospheric temperature is too low.

The Battery Pack has not been charged fully.

Charge runs out
The Battery Pack is completely dead,

quickly.
and cannot be recharged, use another
Battery Pack.
The contrast between the subject and

A vertical strip appears the background is too great for the DVD
on the screen when Camcorder to operate normally. Make
recording a dark the background bright to reduce the
background. contrast or use the BLC function while
you are recording in bright Surroundings.
The Viewfinder lens has not been

adjusted.
The image in the
Adjust the Viewfinder control lever

Viewfinder is blurred.
until the indicators displayed on the
Viewfinder come into sharp focus.
Check the Manual Focus menu.

Auto focus does not
Auto focus does not work in the Manual

work.
Focus mode.
When the power is If the DC Adapter is connected, remove

turned off and then the cord, turn on the Power switch, and
turned on, a blue then connect it again. If the battery is
screen appears instead connected, disconnect it, turn the Power
of the normal screen. switch to on, and then connect it again.
故障排除
 如果故障没有解决，请与三星授权的当地客服中心联系。
现象 原因/排除方法
您无法打开DVD摄像机的

电源。

DVD摄像机自动关闭。



电量很快耗尽。


在拍摄时暗部背景出现垂
直条纹。

取景器中的影象不清楚。 

自动聚焦功能失灵。


关闭电源然后重新打开
时，将出现蓝屏，而不是
正常的屏幕。
中 文
检查电池组或交流适配器。
您将DVD摄像机设置为超过5分钟不使用
它。若要打开DVD摄像机的电源，请按
下[Start/Stop]按钮。
电池组已完全耗尽电量。请换上完全充
电的电池组。
环境温度太低。
电池组未完全充满电。
电池组已损坏而且不能再充电，请更换
新的电池。
物件与背景之间的对比太大，使DVD摄
像机无法正常操作。被摄体与背景的对
比过大，使本机无法正常操作，提高背
景亮度，减少反差或者使用BLC（背光
补偿）功能。
取景器的镜头尚未调节。
调节取景器的控制杆，直至取景器上显
示的指示符位于强聚焦的范围内。
检查手动聚焦菜单。
手动聚焦模式下，自动聚焦不起作用。
若连接的是交流电源适配器，请拔下电
线，打开电源开关，然后再次连接。若
连接的是电池，请断开连接，将电源开
关转到开位置，然后再次连接。
119