Cd Synchro Start Recording; Dubbing Tapes; Recording From Other Sources - Philips FW-C200 User Manual

CD Synchro Start Recording

1
Load a blank tape into tape deck 2 and a disc
into a disc tray.
2
Press CD to select CD mode.
¶ You can programme the tracks in the order you
want them to be recorded (see Programming
Tracks). If not, select the disc by pressing CD
(CD 1•2•3) and the tracks are recorded
according to the order on the selected disc.
3
Press RECORD to start recording.
➜ The
starts flashing.
REC
¶ Disc will start playback automatically.
4 Press Ç to stop recording.

Dubbing tapes

(from tape deck 1 to tape
deck 2)
1
Press TAPE ( TAPE 1•2 ) to select tape deck 2.
2
Load the prerecorded tape into tape deck 1 and
a blank tape into tape deck 2 with full spool to
the left.
3
Press DUBBING.
➜ "DUB" with "2" scrolling right will be displayed.
¶ Dubbing will start immediately.
➜ The
starts flashing.
REC
4
Press Ç to stop dubbing.
Notes:
– At the end of side A, flip the tapes to side B and
repeat the procedure.
– Dubbing of tapes is only possible from tape
deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of the same
length.
– You can switch to other source while dubbing.
pg 01-28/C200/21-Eng

Recording from other sources

(only on tape deck 2)
1
Load a blank tape into tape deck 2 with the
open side downward.
2
Press CD, TUNER or AUX.
¶ Start playback of the selected source.
3
Press RECORD to start recording.
➜ The
4 Press Ç to stop recording.
Notes:
– During recording, it is not possible to listen to
another source.
23
Recording
starts flashing.
REC
3139 115 20143
29/05/2001, 10:13 AM
23