Cd Synchro Start Recording; Dubbing Tapes; Recording From Other Sources - Philips FW-C100 User Manual

Recording

CD Synchro Start Recording

During CD synchro start recording,
¶ Do not fast forward/rewind your tape in tape
deck 2.
1
Load a blank tape into tape deck 1 and a disc
into the disc tray.
2
Press CD.
¶ You can program the tracks in the order you
want them to be recorded (see Programming
Tracks). If you do not, the tracks are recorded
according to the order on the selected disc.
3
Press RECORD on tape deck 1 to start
recording.
➜ The
starts flashing.
REC
4
Press STOP•OPEN on tape deck 1 to stop
recording, then press Ç to stop CD playback.

Dubbing tapes

(from tape deck 2 to tape
deck 1)
1
Load the prerecorded tape into tape deck 2 and
a blank tape into tape deck 1.
¶ Make sure both tapes have their full spool to the
left.
2
Press PAUSE on tape deck 1.
3
Press RECORD on tape deck 1.
➜ The
starts flashing.
REC
4
Press PLAYÉ on tape deck 2.
¶ Recording will start automatically.
5
Press STOP•OPEN on tape deck 1 and tape
deck 2 to stop dubbing.
22
pg 01-27/C100/21-Eng
Notes:
– At the end of side A, flip the tapes to side B and
repeat the procedure.
– Dubbing of tapes is only possible from tape
deck 2 to tape deck 1.
– To ensure good dubbing, use tapes of the same
length.

Recording from other sources

(only on tape deck 1)
1
Load a blank tape into tape deck 1.
2
Press CD, TUNER or AUX.
¶ Start playback of the selected source.
3
Press RECORD on tape deck 1 to start
recording.
➜ The
4
Press PAUSE to interrupt recording.
5
Press STOP•OPEN on tape deck 1 to stop
recording.
Note:
– During recording, it is not possible to listen to
another sound source.
22
starts flashing.
REC
3139 115 20361
29/05/2001, 09:57 AM