Setting Timer; On Timer - Samsung AQ09R Series User Manual

SETTING TIMER

This advanced Timer function allows you to turn on/off your air conditioner automatically even when you are
away. Simply set the time and your air conditioner will turn on/off automatically.

On Timer

This function allows you to turn on the air conditioner automatically within the time range of
24 hours. On timer is available while your air conditioner is off.
1. Press the On Timer button on the remote control.
On timer indicator blinks on the remote control display.
2. Set the time you want the air conditioner to turn on
automatically.
Press the On Timer button on the remote control to
change the time setting while On timer indicator is
blinking.
You can set the time up to 24 hours, increasing in
30 minute unit up to first 3 hours and in hourly unit after
first 3 hours.
3. Press the Set/Cancel button on the remote control to active it on.
The remote control display will show the hour(s) you have set for 3 seconds and
set desired temperature will display.
The air conditioner will operate automatically at set time and then On timer indicator
stops blinking and stays on. If On timer is not set within 10 seconds, the air conditioner
will end setting.
4. Set the operating mode.
Press the Mode button on the remote control until the
desired mode appears on the remote control display.
The air conditioner will operate in the mode you set.
On timer function is available in Auto/Cool/Dry/Fan/
Heat mode.
• Temperature can also be adjusted (see step 3 on page 14 for instructions).
• All the indicators other than On Timer indicator will disappear approximately after
• When the On Timer setting is done, you can press the On Timer button again to change
To deactivate the On Timer
1. Press the Set/Cancel button on the remote control while On Timer is on.
On timer you set will be canceled and On timer indicator will disappear.
AQ09R@@ series_IB_E_29995A_11.25.08.indd 21
10 seconds after the setup.
the preset time. Press the On Timer button to change time setting and then press the
Set/Cancel button to active it on.
using advanced functions _21
2008-11-25 16:39:47