Frymaster Gas Cooker GBC Installation And Operation Manual page 16

1. Between G20- and G25- type Natural Gas, adjust the gas pressure at the gas valve regulator.
(Refer to the CE Standard for Burner Gas Pressure Table on Page 2-7.)
orifices.
nd
2. Between a 2 family (G20 or G25) and a 3
a. Change the orifices.
b. Change the ignitors.
c. Adjust the incoming gas pressure for the new gas. (Refer to the CE Standard for Incoming
Gas Pressure table on Page 2-5).
d. Adjust the burner gas pressure at the gas valve regulator. (Refer to the CE Standard for
Burner Gas Pressure table on Page 2-8 and adjustment procedure in Chapter 4.)
3. Affix the new label included with the conversion kit next to the existing rating plate stating that
the gas type has been converted. Remove any references to the previously used gas from the
existing rating plate. Label PN 802-2144
4. If the destination language changes, replace the labels. (You must contact your local service
agency or KES for label kit. The language of reference is indicated on the corner of the label.)
1. Change the orifices.
2. Change the ignitors.
3. Install the regulator kit in the gas valve in accordance with the instructions furnished with the kit.
4. Adjust the incoming gas pressure for the new gas. (Refer to the Non-CE Standard for Incoming
Gas Pressure table on Page 2-5.)
5. Adjust the gas pressure at the gas valve regulator. (Refer to the Non-CE Standard for Burner
Gas Pressure table on Page 2-8 and adjustment procedure in Chapter 4.)
6. Affix the new label included with the conversion kit next to the existing rating plate stating that
the gas type has been converted. Remove any references to the previously used gas from the
existing rating plate. Label PN 802-2144
7. If the destination language changes, replace the labels. (You must contact your local service
agency or KES for a label kit. The language of reference is indicated on the corner of the label.)
CE Gas Conversion Instructions
rd
family gas (G31 Propane):
Non-CE Gas Conversion Instructions
2-9
Do not change the