Do not load items above
top row of holes in wash tub.
Built-In FabricSoftener Dispenser
Built-In Fabric Softener Dispenser
6. Add laundry
load to washer.
Dry load level should not be higher than top row of holes in wash tub.
Do not overload
Do not put items on top of agitator or wrap them around it. Load items
Combine large and small items in a load. Load large items first. Large items
should not be more than half the total wash load.
When washing a single heavy item, add 1 or 2 towels to balance the load.
For models with a built-in
dispenser (see picture to the left):
Add liquid softener to the dispenser, following
fabric softener label
Add water to bring liquid level to fill line on dispenser cap.
Remove the dispenser from the agitator after each use. Rinse both cap and
cup with warm water. Replace dispenser in the agitator.
NOTE: To separate cap from cup, put thumb into dispenser and push against
side of cup (see picture to the left). After cleaning, push cap and cup firmly
together. Replace dispenser by lining up the ribs and grooves and snapping it
Fabric softener will be flushed from area under the builtqn fabric softener
dispenser when Large Load Water Level is selected. If a build-up of fabric
softener occurs, clean with hot water. DO NOT REMOVE SERVICE CAP.
For models with a removable dispenser (see picture below to the left):
Attach fabric softener dispenser to top of agitator by pressing down gently.
Add softener to the dispenser, following fabric softener label directions.
Add water to bring liquid level to top of the peg in the center of the cup.
Remove the dispenser from the agitator after each use. Rinse both lid and
bowl thoroughly with warm water. Reassemble and place dispenser on
agitator or store it nearby.
For models without
a fabric softener dispenser, follow fabric softener label
directions. Add diluted fabric softener to the final rinse. Do not pour fabric
directly on the wash load.
8. Set cycle selector
knob and washer
type, size, and soil level of each load, and detergent
Instructions for your specific model controls.