Important Information About Water And Shock Resistant Features - Olympus TG-1 Instruction Manual

To attach/remove the conversion lens/fi lter To attach/remove the conversion lens/fi lter
Conversion lens
• To attach the lens ring or converter adapter to the camera, align the marks and screw it in the direction of attaching
until it clicks into place.
• For details, please visit the Olympus website for your local area.
Important information about water
and shock resistant features
Water resistance: The waterproof feature is warranted
operate at depths up to 12 m (39.8 feet) for up to one hour. The
waterproof feature may be compromised if the camera is subject
to substantial or excessive impact.
Shock resistance: The anti-shock feature warrants
operation of the camera against accidental impact incurred from
everyday use of your digital compact camera. The anti-shock
feature does not unconditionally warrant all defective operation
or cosmetic damage. Cosmetic damage, such as scratches and
dents, are not covered under the warranty.
Converter
adapter
Remove
direction
Filter
φ40.5
*1
to
*2
the
Attach
direction
As with any electronic device, proper care and maintenance are
required to preserve the integrity and operation of your camera.
To maintain camera performance, please take your camera
to the nearest Olympus Authorized Service Center to have it
inspected after any major impact. In the event the camera is
damaged as a result of negligence or misuse, the warranty will
not cover costs associated with the service or repair of your
camera. For additional information on our warranty, please visit
to the Olympus website for your local area.
Please observe the following care instructions for your camera.
*1 As determined by Olympus pressure testing equipment
in accordance with IEC Standard Publication 529 IPX8 -
This means that the camera can be used normally under
water at a specifi ed water pressure.
*2 This anti-shock performance is confi rmed by Olympus'
testing conditions in accordance with MIL-STD-810F,
Method 516.5, Procedure IV (Transit Drop Test). For
more details of Olympus' testing conditions, please refer
to the Olympus website for your local area.
Marks for attaching
69
EN