Motorola Electrify 2 User Manual page 42

2 Make sure the switch at the top is
SCAN
.
3 Touch a found network to connect it (if necessary,
Network SSID Security
enter ,
Connect
and touch ).
When your phone connects, the Wi-Fi status
indicator appears in the status bar.
Note: If you see a question mark in the Wi-Fi status
indicator , pull down the status bar, touch the
network, and enter the network's password.
Tip: When Wi-Fi power is on, your phone automatically
reconnects to available networks it has used before
Manage networks
To remove a network, touch it in the list, then touch
Forget
.
To manage your networks, touch Apps
Wi-Fi
> , turn Wi-Fi power on, then touch Menu
Manage Networks
> .
Wi-Fi hotspot
Your can make your phone a Wi-Fi hotspot to provide
portable, convenient internet access to other Wi-Fi
enabled devices.
Note: Keep it secure. To protect your phone and hotspot
from unauthorized access, it is strongly recommended
40 Connect & transfer
, then touch
ON
Wireless password
, and
Settings
>
that you set up hotspot security (WPA2 is the most
secure), including password.
Find it: Apps
Hotspot
, and check
1 Your phone turns off
network for Internet access. Touch
Settings Configure Mobile Hotspot
>
• SSID—Enter a unique name for your hotspot.
• Security—Select the type of security you want:
Open
or
password that others will need to access your
Wi-Fi hotspot.
WPA2
Note:
• Channel—If you notice interference after your
hotspot has been active for a while, try different
channels.
Save
2 Touch
Mobile Hotspot
When
devices can connect by entering your hotspot's
Security
selecting a
Wireless password
Wi-Fi modes
For those who like to get a bit more technical, your
phone supports the following Wi-Fi modes:
802.11a, b, g, n.
Settings Tethering & Mobile
> >
Mobile Hotspot
.
Wi-Fi
power and uses the mobile
WPA2 WPA2
. For , enter a unique
is recommended by IEEE.
when the settings are complete.
is active, other Wi-Fi enabled
type, and entering the correct
.
Mobile Hotspot
to set up security:
SSID
,