Honda 2010 Insight Owner's Manual page 410

Checking and Replacing Fuses
If something electrical in your
vehicle stops working, the first thing
you should check for is a blown fuse.
Determine from the chart on pages
410 and 411 , or the diagram on the
fuse box lid, which fuse or fuses
control that device. Check those
fuses first, but check all the fuses
before deciding that a blown fuse is
the cause. Replace any blown fuses,
and check if the device works.
Turn the ignition switch to the
1.
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
Remove the cover from the under-
2.
hood fuse box located on the
battery (see page 406 ).
3. Check each of the large fuses in
the under-hood fuse box on the 12
volt battery by looking through
the top at the wire inside.
Replacement of these fuses should
be done by your dealer.
2010 Insight
BLOWN
4. Check the smaller fuses in the
under-hood fuse boxes and all the
fuses in the interior fuse box by
pulling out each one with the fuse
puller provided in the interior fuse
box.
Fuses
FUSE PULLER
CONTINUED
407