Honda 2010 Insight Owner's Manual page 369

Lights
BOLT
5. Remove the two mounting bolts
with an 8 mm wrench.
366
ORIGINAL
POSITION
6. Pull the rear of the light assembly
out as shown in the illustration
above ( ), then push the
assembly back to the original
position carefully ( ). The front
part of the rear light assembly
raises slightly ( ).
7. Determine which of the three
bulbs is burned out: back-up light,
turn signal, or side marker.
2010 Insight
Front
Left side
Front
BULB
SOCKET
Left side
8. Pull the whole light assembly
outwards from the body carefully.
9. Remove the socket by turning it
one-quarter turn counterclockwise.
10. Remove the burned out bulb by
pulling it straight out of its socket.
SNAP FASTENERS