BOLT
WASHER
4.
Remove the oil drain bolt and
washer from the bottom of the
engine. Drain the oil into an
appropriate container.
5.
Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Make sure the oil filter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
before installing a new oil filter.
2010 Insight
Changing the Oil and Filter
6.
Install a new oil filter according to
the instructions that come with it.
Make sure to clean off any dirt
and dust on the contacting surface
of a new oil filter.
7.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
29 lbf·ft (39 N·m , 4.0 kgf·m)
OIL FILTER
8.
Refill the engine with the
recommended oil.
Engine oil change capacity
(including filter):
3.4 US qt (3.2 )
CONTINUED
351