Haier HWMP55-918 User Manual page 14

Operation & Wash Cycles
3
Press the
Wash
Even there is no water in the tub a certain period is required before spinning
Separate colour fast clothes before loading washing machine.
During Rinse cycle, only SPIN times can be set, all other wash functions are locked.
During Wool and Tub Dry cycles, these settings cannot be changed and buttons will
not function, as machine will only follow pre-programmed settings.
4
Press the
For the "Synthetic"and "Memory" cycles the machine will run a Fuzzy Logic program
that automatically detects the type of laundry in the tub. After detection
it will set the water level automatically.
The water level can only be changed once the machine has started by pushing the
"Start/Pause" button, then push the "Water Level" button to reset the water level.
Press the "Start/Pause" button to resume the wash cycle
5
Temp
Press the
Wash/Rinse
Set the wash and rinse temperatures in accordance to the requirements of each
load. The wash and rinse temperatures will be the same (i.e. if
is selected, both wash and rinse cycles will be warm/cold).
6
Press the
The delay time program is automatically off, and wash cycles will start as soon as
Start/Pause
To set a delay time, first select the Cycle and options required and push the
Delay" button
The cycle indicator lights will go off and the "Delay (Hours) indicator light will be on.
During the delay program, press the "Delay" button to display the time remaining.
The delay time indicator shows the time remaining till the wash ends.
To cancel the delay program, switch the power off and back on, then make a new
selection.
Delay start (2-24hr) option
Delay time is to the end of washing washing cycle
buttons to customise the pre-set options
Rinse Spin
Water Water
button to
Level Level
button to select the the wash and rinse temperature
button to select the delay wash program
Delay
button is pushed.
change the water level
12
Warm/Cold
The wash will finish
in about 18 hours