Table of Contents
Advertisement
Remember not to exceed the
Gross Axle Weight Rating
(GAWR) of the front or rear axle.
Ladder Rack
340 kg
and Cargo
(750 lbs)
Cross Toolbox
181 kg
and Cargo
(400 lbs)
Side Boxes
113 kg per
and Cargo
side (250 lbs
per side)
*The combined weight for all
rail-mounted equipment should
not exceed 454 kg (1,000 lbs).
A reinforcement kit for
rail-mounted add-on equipment
is recommended. See your GM
dealer.
A. Primary Load Points
B. Secondary Load Areas
C. Cargo Management Option
Holes
Structural members (A) and (B) are
included in the pick-up box design.
Additional accessories should use
these load points. Depending on the
accessory design, use a spacer
under the accessory at the load
points to remove gap. The holes for
the Cargo Management System (C)
are not intended for attachment of
aftermarket equipment. See
www.gmupfitter.com for additional
pick-up box load bearing structural
information.
A vehicle-specific Truck Camper
Loading Information label is
attached to the inside of the
vehicle's glove box. This label
indicates if a slide-in camper
can be carried, how much of a
load the vehicle can carry, and
how to correctly spread out the
load. It will help to match the
right slide in camper to the
vehicle.
Your dealer can help make a
good vehicle-camper match and
help determine the Cargo
Weight Rating (CWR).
When installing and loading a
slide-in camper, check the
manufacturer's instructions.
Advertisement
Table of Contents
