Bosch Tassimo Tas 55XX Instruction Manual page 38

36
Problem
Appliance not working;
no symbols light up.
Machine brews but no
drink dispensed.
Drink size smaller than
usual.
More steam than usual.
The appliance does not
recognise the inserted
T DISC and remains in
stand­by mode or the
Status LED lights up
F
red.
The quality of the foam /
crema has deteriorated.
Robert Bosch Hausgeräte GmbH
TAS55.indb 36
Possible!cause
There is no power supply. Check that the appliance is prop­
The water tank is not
correctly positioned.
The water tank was
removed during the brew­
ing process or there is air
in the system.
The loat in the water
tank is stuck.
Not enough water in the
water tank.
The appliance needs
descaling.
The appliance needs
descaling.
No T DISC inserted.
The barcode could not be
detected.
The brewing system is
not properly closed.
The drink outlet is
clogged or dirty.
The appliance needs
descaling.
Solution
erly plugged into the power supply.
Make sure that the water tank is
positioned correctly.
Start a cleaning cycle with the
Service T DISC.
Clean the water tank and ensure
the loat can move.
Fill the water tank after the drink
has inished dispensing and press
the start / stop button to inish the
drink.
Descale the appliance (for details
see "Descaling").
Descale the appliance (for details
see "Descaling").
Check if T DISC has been inserted.
Clean the T DISC barcode reading
window and try again or smooth
the barcode on the T DISC out with
your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline
08 00 032 88 33 (UK only)
Clean the brewing system thor­
oughly, especially in the area of the
clamp.
Remove the drink outlet from the
brewing unit and detach the pierc­
ing unit. After cleaning everything
thoroughly, reassemble the parts
and replace them in the brewing
unit.
Clean the brewing unit with the
Service T DISC.
Descale the appliance (for details
see "Descaling").
en
26.08.2011 10:38:20