Table of Contents
Advertisement
Tips
Tips
Care of the screen
Poor Picture
No Picture
Digital distortion
No sound
No Surround
sound
No solution found
for your picture or
sound problem ?
Menu
Remote control
Standby
No stable or not
synchronised VGA
picture
TV receiver box
with speakerless
r
monito
Miscellaneous
Clean the TV with a slightly damp soft cloth. Do not use abrasive solvent as it can
damage the TV screen.
• Have you selected the correct TV system in the manual installation menu?
• Is your monitor or house aerial located too close to loudspeakers, non-earthed
audio equipment or neon lights, etc.?
• Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of the
aerial.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
frequency. See Installation, p. 6.
• Are brightness, sharpness and contrast out of adjustment? Select Factory
settings in the Setup, General menu, p. 8.
• Are the supplied cables connected properly ? (The aerial cable to the receiver
box, the other aerial to your recorder, the VGA cables to the display, the power
cables.)
• Has the child lock been switched off ?
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the monitor lights up
green, this means that the display mode is not supported. Switch your
VGA-source to a correct mode.
• In case of weak or bad signal, consult your dealer.
The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Picture menu, Smart Picture,
without changing the picture settings manually.
• No sound on any channel? Check the volume isn't at minimum.
• Is the sound interrupted with the mute key ¬?
• Check if the headphone is not plugged in.
• Perhaps the channel is not broadcasting good quality surround sound.
• No sound from the rear speakers or the centre speakers? Select an appropriate
surround mode, according to the broadcasted sound signal or adjust the
volume. See Surround Modes, p. 11.
Switch your TV off and then on again once. Never attempt to repair a defective
TV yourself. Check with your dealer or call a TV technician.
Have you selected the wrong menu? Press the
menu.
• Check if the remote control is in the correct mode.
• If your TV no longer responds to the remote control, the batteries may be dead.
• You can still use the
Your TV consumes energy in the standby mode. Energy consumption contributes
to air and water pollution.
Check if you have selected the correct VGA mode in your PC. See the separate
instruction manual with the monitor.
In case you connect your TV receiver box with a speakerless monitor, and
without having connected an audio receiver, all references made in this
instruction book to sound reproduction, volume control, and audio connections,
are not applicable (except for a headphone connection).
The keys on the remote control referring to sound have no function either.
. Ambient temperature: + 5~ + 40°C
. Mains: 50/60 Hz Auto Voltage ranging from 95 V to 264 V
. Power consumption: around 35 W
. Standby consumption: 2 W
.Weight (excl. packaging): 4 kg
. Dimensions (wxhxd): Receiver: 43.5 x 10.5 x 33 cm
MENU
key and the -/+ keys at the top of your TV.
key again to exit from the
MENU
20
Advertisement
Table of Contents
