Engine Control System (Eobd) Failure - Alfa Romeo 156 Owner's Manual

Message
Warning light
on display
U
98

ENGINE CONTROL SYSTEM (EOBD) FAILURE

In normal conditions, turning the ignition key to MAR, the dial warning light turns on but it should
go off when the engine has started. The initial turning on indicates that the warning light is work-
ing properly.
If the warning light stays on or turns on (together with the message + symbol shown on the dis-
play) when travelling:
glowing steadily - indicates a fault in the supply/ignition/injection system which could cause
high exhaust emissions, possible lack of performance, poor handling and high consumption levels.
In these conditions, it is possible to continue driving without however demanding heavy effort or
high speeds. Prolonged use of the car with the warning light on may cause damage. Contact an
Alfa Romeo Authorized Service as soon as possible.
The warning light turns off if the fault disappears, but it is still stored by the system;
flashing - indicates that the catalyst could be damaged (see paragraph on "EOBD system" in this
chapter).
If the warning light flashes, it is necessary to release the accelerator pedal to lower the speed un-
til the warning light stops flashing; continue travelling at moderate speed trying to avoid driving
conditions that could cause the warning light to flash again. Contact an Alfa Romeo Authorized Ser-
vice as soon as possible.
If, when turning the ignition key to MAR, the warning light U does
not switch on or if it turns on glowing steadily or flashing when trav-
elling, contact Alfa Romeo Authorized Service as soon as possible. The
operation of the warning light U can be checked by traffic agents by proper
equipment, therefore comply with the regulations in force in the country where
you are driving.