Phaser - LinPlug Albino 3 Manual

Rate parameters; setting the Spread Time and Rate to 0 cancels the effect;
increasing the value of the Spread Time and Rate parameters adds
additional richness and fullness to the sound. It can also make the effect
sound more natural.
Chorus 2 has fewer parameters than Chorus. These are: Wet, Time and
Rate. This controls are the same as those of Chorus so see above for more
information. Chorus 2 has a different internal structure to Chorus which
producesa different type of sound. The sound of Chorus 2 is richer but less
natural sounding that Chorus.

Phaser

The Albino Phaser can be used to create "swirling" dynamic movement in
sounds. The Phaser effect is created by automatically sweeping a series of
equally spaced frequency notches up and down the audio spectrum. The
Albino's Phaser features controls for "Wet", "Rate", "Depth", "Center",
"Feed", "Inv" (Invert), "Stereo" and "Stages".
The Wet dial allows you to set the balance between the processed "wet"
signal and the original unprocessed "dry" signal.
The Rate dial sets the rate at which the signal is modulated. The Depth
dial is used to set the depth to which the signal is modulated.
The Center dial is used to set the frequency around which modulation
occurs.
The "Feed" (Feedback) control is used to set the amount of internal
feedback employed within the phaser. More internal feedback produces
increasingly pronounced resonant peaks.
The Inv (Invert) button allows you to invert the signal that is used to create
the phasing effect.
Rob Papen Albino 3.0 46