Filter - LinPlug Albino 3 Manual

The Feedback control is used to set the amount of signal the is fed back to
the effect's input, thus producing a stronger, more pronounced and richer
effect.
The Inv(erse) Feedback control inverts the phase of the feedback signal
which again, changes the character of the output sound. The most
pronounced effects are created when both Inv controls (wet and feedback)
are either set to Off or On.
The Stereo control creates separate flanging effects for each of the stereo
channels. The creates adds width to the effect. This parameter is normally
used sparingly, but can be useful at higher settings.
The Modulation Depth Time is the key parameter for setting the strength of
the flange effect. Higher settings create a more pronounced effect.
The Modulation Rate control is used to set the speed of the flange effect
(the speed of the cyclic changes between the two tape machines). This
parameter can be set either directly with the dial or as a fraction of the
song's tempo using the display below the Rate dial.
The Rate Sync control is used to synchronise the flanger's modulation rate
with the song's current tempo.
The Mod(ulation) Depth Pan control is a parameter unique to the Albino,
and is not normally on flanger effects. This control enables the stereo
position of the flanged signal to be modulated at the same speed as that of
the Rate control.

Filter

This effect module is an additional monophonic filter that incorporates
saturation/distortion. It can be used to create some very special distortion/
overdrive sounds.
Rob Papen Albino 3.0 48