LinPlug MorphoX User Manual page 14

detuning among these voices. When moved from the bottom position the
slider gradually detunes the voices to produce a thick and fat sound.
While oscillator one uses five voices and produces a more thick sound,
oscillator two uses three voices and thus sounds different which might be
better suited for certain sounds.
Oscillator 1
The Phase parameter does allow to specify at which point in the
waveforms cycle the oscillator starts from. This parameter has no effect in
case the oscillator is set to run free (see above: Free-run). The Phase is
particularly interesting for certain types of sounds (mainly Bass), but also
when Oscillator 1 is used for FM or AM (FM and AM are explained in the
Glossary) of either the Oscillator 2 or the Filter.
Between the two oscillators you find the Detune dial, which allows you to
adjust both oscillators' frequency in two different directions to create the
typical "swirling" or "detuned" sound.
Oscillator 2
The FM controller will adjust the amount of frequency modulation of
Oscillator 2 through Oscillator 1. This type of modulation is great for
producing metallic, bell-like tones and can also be used to produce rich and
complex waveforms.
LinPlug MorphoX 1.0 14