Reversing The Door Hinge; Door Alignment - Black & Decker BNA17 Use & Care Manual

English

Door Alignment

1. Remove the top hinge cover using a flat head screw driver. Gently lift from the
rear of the hinge and slide forward.
2. Loosen the top hinge screws using a phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover by sliding the hinge cover from front and press
gently on the rear of the hinge cover to lock in place.

Reversing the Door Hinge

(Optional: To Change Direction Door Opens)
1. Remove the top hinge cover using a flat head screw driver. Gently lift from the
rear of the hinge and slide forward. (see Fig.1)
2. Using a Phillips Head Screwdriver, loosen and remove the screws holding the
top hinge in place. (see Fig. 2)
Screw Hole Plug
3. Remove the top hinge and carefully lift off the door.
4. Remove the screw hole plug from the opposite side and insert the plug in the
screw hole openings of the just removed screws.
5. Loosen the screws holding the lower hinge bracket and remove the hinge.
6. Remove the screws from the bottom of the front-left corner plate.
5
(If Needed)
1 7cu.ft NuCool
Fig.1
Fig.2
Hinge on right side
Top Hinge
Lower Hinge
6
Bottom View