Door Alignment; Starting Your New Refrigerator - Black & Decker BCRK32 Series Instruction Manual

SET UP & USE
PROTECTION FROM HEAT AND MOISTURE
• Do not install your refrigerator in any location where heavy moisture is present
or if the location is not properly insulated. This refrigerator is not designed to
operate in temperature setting below 55° Fahrenheit.
• Location for the refrigerator should be on a hard surface and away from direct
sunlight and heat source, e.g., radiators, baseboard heaters, cooking appliances,
etc.

DOOR ALIGNMENT

1. Remove the top hinge cover.
2. Loosen the top hinge screws using a Phillips head
screwdriver.
3. Adjust the door or put a spacer in between and then
tighten the screws.

STARTING YOUR NEW REFRIGERATOR

After cleaning your refrigerator thoroughly. Wipe the outside with a soft dry cloth,
the interior with a clean moist cloth.
1. Insert the power supply cord into the socket.
2. Turn the thermostat dial to an initial setting of "7" for 15-20 minutes.
NOTE: · As the door gets pressed in during shipping, the gasket may have to be reset. This is
done to prevent the cool refrigerated air from escaping. If there is a gap between the
door gasket and the cabinet, set the gasket by gently pulling it out of the seal gap.
Door Hinge Cap
Page 7