Installing Your Refrigerator; Electrical Requirement - Black & Decker BNA17 Use & Care Manual

English

Installing Your Refrigerator

Unpacking Your Refrigerator
1. Inspect and remove all packing materials. This includes the foam and any
adhesive tape both inside and outside of the unit.
2. Inspect and remove any remains of packing, tape, or printed materials before
powering on your appliance.
Proper Air Circulation
• To assure your refrigerator works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation and
electrical connections.
• The following are recommended clearances around the refrigerator:
Sides .......................2 "(50mm)
Top .......................2" (50mm)
Back ....................4" (100mm)
Leveling Your Refrigerator
• Your refrigerator has four (4) leveling legs which are located in the corners of your
refrigerator. After properly placing your refrigerator in its final position, you can
level your refrigerator.
• Leveling legs can be adjusted by turning them clockwise to lower your refrigerator
or by turning them counterclockwise to raise your refrigerator. The refrigerator
door will close easier when the front leveling legs are extended.
WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD

Electrical Requirement

• Make sure there is a suitable power outlet (115 volts, 15 amps outlet)
with proper grounding to power the refrigerator.
• Avoid the use of three prong adapters or cutting off the third
grounding prong in order to accommodate a two prong outlet. This is
a dangerous practice since it provides no effective grounding for the
refrigerator and may result in shock hazard.
3