Advertisement
Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to that below will
appear. If you want to install Windows XP, use the ARROW keys to select ALi SATA RAID Controller
(M5289, Windows XP/Server 2003)* (Figure 20) and press ENTER. Then it will begin to load the
SATA driver from the floppy disk.
Step 4:
When the screen as shown below appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
If a message appears saying one or some file(s) cannot be found, please check the floppy
disk or copy the correct SATA driver again from the motherboard driver CD.
Windows Setup
* To specify additional SCSI adapters, CD-ROM drives, or special
* If you do not have any device support disks from a mass storage
S=Specify Additional Device
"*" Select the driver according to which of the following operating systems you want to install:
Windows 2003, Windows XP, Windows 2000, or Windows 2003/XP AMD 64-bit Edition.
SATA Hard Drive Configurations (ULi M1689)
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ALi SATA RAID Controller(M5289, Windows XP/Server 2003)
ALi SATA RAID Controller(M5289, Win2000)
ALi SATA RAID Controller(M5289, Windows XP/Server 2003 AMD 64-bit Edition)
ENTER=Select F3=Exit
Setup will load support for the following mass storage device(s):
ALi SATA RAID Controller(M5289, Windows XP/Server 2003)
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Figure 20
Enter=Continue F3=Exit
Figure 21
- 14 -
Advertisement
