Disconnecting From The Pc - FujiFilm FinePix 2600 Zoom Owner's Manual

DISCONNECTING FROM THE PC ( Important — always use this procedure. )
1
1Quit all applications (FinePixViewer,
VideoImpression, etc.) that are using the
camera.
2Check that the viewfinder lamp is glowing
green (that the camera is not communicating
with the computer).
For a PC CAMERA connection, proceed to
step 3 .
G
!
Even after the "Copying..." message is no longer
displayed on your computer, communication with the
camera may still be in progress. Always check that
the viewfinder lamp on the camera is glowing green
68
and is no longer flashing.
Perform the steps shown below before you
2
switch the camera off. This procedure
differs depending on the operating system
software (or PC) you are using.
Windows 98 or 98 SE
No PC operation is needed.
Windows Me
Left-click the Eject icon in the taskbar and eject
"USB disk".
✽ Display this message and then click the "OK" button.
Windows 2000 Professional
Left-click the Eject icon in the taskbar and eject
"USB Mass Storage".
✽ Display this message and then click the "OK" button.
Macintosh
Drag the "Removable drive" icon on the desktop
to the Trash.
3
1 0
(USB)
socket
1Switch the camera off.
2Unplug the special USB cable from the
camera.
G
!
If you are using Windows, you cannot disconnect the
camera by right-clicking the removable disk icon (the
camera) and selecting "Eject". Always follow the
proper procedure as given above before
disconnecting the camera from your PC.
2 0
6
69