Connecting At Pc-Camera Mode - FujiFilm FinePix 2800 Zoom Owner's Manual

CONNECTING AT PC-CAMERA MODE

1
1 0 0 2
1Remove the lens cap.
2Press the "POWER" button to switch the
camera on.
3Set the "USB MODE" setting in the "SET–UP"
menu to "PC CAM" (➡P.62, 63).
4Press the "POWER" button to switch the
camera off.
G
!
You should use the AC power adapter when the camera
is connected to your PC (➡P.19). Loss of power during
data transmission can prevent successful data
70
downloading.
2
4 0
(Special USB) (Special USB)
socket socket
(USB)
3 0 DC IN 5V Socket
Socket
Camera
1Switch your PC on.
2Use the special USB cable to connect the camera to
your PC.
3Switch the camera on.
On Windows PCs (excluding Windows XP), if the
"Add New Hardware" wizard appears, close the
wizard and switch off the camera. You must install
the software before connecting the camera to your
PC. (➡Software Quick Start Guide booklet)
Always use the prescribed procedure when
disconnecting or switching off the camera (➡P.72).
G
!
If you are using Windows XP, you must also refer to the
Software Quick Start Guide booklet.
G
!
Take care to connect the plugs on the special USB cable
into the correct sockets, and ensure that the plugs are
inserted firmly.
Camera Operation
PC
i The indicator lamp alternately blinks green and
orange while the camera is communicating
with your PC.
i The lens is fixed at the wide-angle zoom
setting.
i "PC CAM" appears on the screen.
i The camera does not automatically switch off
when a USB connection is being used.
G
!
Do not disconnect the USB cable when the camera
is communicating with the PC. See P.72 for
information on the disconnection procedure.
PC Operation
i FinePixViewer automatically starts up and the
Picture Hello window opens (Windows only).
✽ Screen for Windows 98 SE
i You can use software
such as VideoImpression
to view live images.
✽ Screen for Macintosh
If the above operations do not occur, you do not
have the required software programs or drivers
installed on your PC. Refer to the Software
Quick Start Guide booklet and complete the
required PC setup procedures. Then reconnect
the camera to your PC.
6
71